Here is an example of a plastic lens repair with a wrinkle. Since we will be using various compounds that cut and polish the lens it would also do the same to the surrounding paint. So here is how we protect the paint when making the plastic repair. Top left in the photo shows the scratches in the lens. Notice also that paper and several layers of masking tape are being used to isolate the plastic from the surrounding paint. Next in the upper right the scratch is wet sanded with ultra-fine 1500-2000 grit sandpaper. This is followed by rubbing and polishing with compound either by hand or with a low speed drill motor, see photo lower left. To complete the repair the lens is polished and buffed to a high luster and then the tape and paper is removed leaving the surrounding paint unaffected. To proceed to the next section that describes the EVALUATING AND ESTIMATING click here. To go to the other subjects covered in this section: To open the panel on the CABINET REPAIR click here To open the panel on the DISSASEMBLY click here To open the panel on the CLEANING MATERIALS click here To open the panel on the FUNCTION BUTTON RENEW click here To open the panel on the PLASTIC REPAIR click here ©Misterßetamax go to homepage